Installing in Borehole
1
Saturate filter and piezometer. Flush borehole with clean water. Check that it functions
correctly and note “zero” readings of VWP. Lower into borehole to
required depth.
2
Place sand around tip using tremie pipe. Sand must be wet to tremie successfully.
Check that it functions.
3
Place bentonite seal. Drop pellets or chips into borehole slowly to avoid bridging. Add water as
needed for hydration of bentonite. Allow time for bentonite to swell.
4
Fill remainder of borehole with bentonite or bentonite-cement grout.
5
Terminate tubing or cable to prevent entry of water. Top off borehole with grout and install protective
cover. Prove installation and obtain initial reading, then hand over to client.
3-23
Rembco Geotechnical Contractors specializes in
slope stabilization,
soil nail wall,
foundation repair
and support,
grouting,
shoring,
micropile
construction,
rock drilling, and we remediate
sinkholes. We use a
problem-solving approach in the geotechnical portions of buildings, bridges, water plants, sewage plants, tunnels,
installing caisson bottom, and roads. We are experienced in these applications:
micro piles,
sinkhole repair,
permeation and
pressure
grouting,
soil nails,
cement grouting,
chemical grouting,
micropiles,
compaction grouting, and
rock anchors.
Rembco techniques apply when adding new structures: especially
rock anchor,
microfine cement,
soil nailing, and
micropile
installations for foundation support. Our specialties are
soil nails,
rock anchor,
chemical and
compaction grouting,
mini piles,
sinkhole repair,
micropiles, and
soil nailing.
