Micro Piles  |  Pressure Grouting  |  Rock Anchors  |  Permeation Grouting   |  Micropile
Soil Nailing  |  Compaction Grouting  |  Micropiles  |  Chemical Grouting   |  Soil Nail Wall


General Construction Specifications

    SECTION 16140

    WIRING DEVICES

   PART 1 GENERAL

    1.01 Submittals:

    A. Submittals are required for materials covered in this section. Refer to Section 16010 for definitions and direction for preparation and submission.

    B. Product data on all wiring devices and faceplates shall be submitted as outlined.

   PART 2 PRODUCTS

    2.01 Switches:

    A. All switches shall be 120 volt, 15 or 20 amp specification grade type gray devices.

    B. Single pole switches shall be Hubbell No. CS115-GRY or CS120-GRY style or equivalent by Arrow-Hart, P&S or Bryant. Three-way switches shall be Hubbell No. CS315-GRY or CS320-GRY or equivalent by Arow-Hart, P&S, or Bryant.

    2.02 Receptacles:

    A. All general purpose receptacles shall be specification grade grey devices as indicated on the drawing and shall be Hubbell No. CR15 or CR20 or equivalent by Arrow-Hart, P&S, or Bryant. Special purposes wiring devices shall be as follows:

    GFI receptacle: Pass-Seymour 1591-SGRY

    Weatherproof: Pass-Seymour 3780-SC

    Surge Suppressor: Pass-Seymour 6262-GRYSP

    Surge Suppressor Pass-Seymour

    w/orange isolated IG-6262-OSP

    ground

    2.03 Coverplates:

    A. Coverplates for surface mounted boxes shall be galvanized to match the cast metal boxes.

    B. Coverplates in wet or damp locations shall be weatherproof.

   PART 3 EXECUTION

    3.01 Installation:

    A. All outlets shall be polarized with the respective phase wire, neutral and ground on the identical terminal on all receptacles.

    B. The ground pin on all receptacles shall be installed above the phase and neutral blades.

    C. Provide ground fault interrupter devices at outside receptacles, unless noted otherwise.

    END OF SECTION

This Section: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33
Sections
: 1 2 3 4 6 7 8 9 10 11 13 14 15 16

Rembco Geotechnical Contractors specializes in slope stabilization, foundation repair and support, shoring, grouting, soil nails, micropile installations, and sinkholes. We are experienced in these applications: micro piles, sinkhole repair, permeation grouting, pressure grouting, soil nails, chemical grouting, micropiles, compaction grout, rock anchors and compaction piles. Our specialties are rock anchor, chemical and compaction grouting, mini piles, sinkhole repair, micropiles, and soil nailing. We use a problem-solving approach in the geotechnical portions of buildings, bridges, water plants, sewage plants, tunnels, sinkholes, caisson, and roads. Rembco techniques apply when adding new real estate structures: especially rock anchor, microfine grouting, soil nailing, micropile installations for foundation support. Add URL Construction, Drilling and Concrete